Just to add to what Compton wrote, I would like you to check if you can load Windows in safe mode
https://www.digitalcitizen.life/4-ways-boot-safe-mode-windows-10
https://www.digitalcitizen.life/4-ways-boot-safe-mode-windows-10
disable Windows 10 Update Assistant
|
Just to add to what Compton wrote, I would like you to check if you can load Windows in safe mode
https://www.digitalcitizen.life/4-ways-boot-safe-mode-windows-10
what version of windows 10 are you using? is it build 10240?
Page fault in nonpaged area?
Do have a page file? Have you installed new hardware into your computer recently? Is all your hardware seated properly? And also take a look at this link i think itll help you out. https://www.online-tech-tips.com/computer-tips/page-fault-in-non-paged-area-error/
11-12-2017, 03:51 PM
(11-11-2017, 11:35 PM)Compton Wrote: post bosd reports if you can After Windows 10 Update Assistant finishes i have to restore my system from backup. how can i run WhoCrashed etc?
11-12-2017, 04:12 PM
if you select Link one it would tell you how to to run it
(11-11-2017, 11:35 PM)Compton Wrote: post bosd reports if you can Im trying to post my results from SFC but it will not accept the file (11-12-2017, 06:23 AM)f23948 Wrote: what version of windows 10 are you using? is it build 10240? yes
ok did SFC find any corruption?
(11-12-2017, 07:28 PM)Compton Wrote: ok did SFC find any corruption? yes, ran sfc again it says " Microsoft Windows [Version 10.0.15063] © 2017 Microsoft Corporation. All rights reserved. C:\WINDOWS\system32>sfc /scannow Beginning system scan. This process will take some time. Beginning verification phase of system scan. Verification 100% complete. Windows Resource Protection did not find any integrity violations. "
11-12-2017, 08:22 PM
ok what manufacturer is the mouse?
|
Users browsing this thread: |
1 Guest(s) |